Sanding block, 50 mm/5 mm/0°

The thickness of sanding blocks with an angle of 0° is including sanding paper (for sanding paper thickness of 0.6 mm, i.e. the block is smaller by 1.2 mm from the nominal size).

The blocks are marked with an angle and a number that expresses the needed length of the sandpaper without folds. The sandpaper is fixed on one side in a groove (either without a fold for thicker papers, or with a fold for fine or thinner papers) and by means of a tightening block, which is attached with a screw and a nut. This set does not contain sandpaper, it must be purchased separately (see MPJ 9645XX).

Available in two variants - economy and standard.

The economic variant includes hex screw with a cylindrical head M4x12 mm (MPJ 0430 SB), M4 nut (MPJ 0108 SZ) and a washer (MPJ 0704 SZ) for clamping the sandpaper. The set does not include a 3 mm Allen key (MPJ 0903 SB).

The standard variant includes M4 knurled screws (MPJ 1528) and M4 nuts (MPJ 0108 SZ) for sandpaper clamping.

Package contents: 1 pc